From d4203520d0b5eb6fecaee38d4f64373d3c7cd148 Mon Sep 17 00:00:00 2001 From: Leah Rowe Date: Fri, 11 Oct 2024 17:21:59 +0100 Subject: [PATCH] update notes about dell 3050 micro Signed-off-by: Leah Rowe --- site/docs/install/dell3050.md | 15 +++++---------- 1 file changed, 5 insertions(+), 10 deletions(-) diff --git a/site/docs/install/dell3050.md b/site/docs/install/dell3050.md index f7e6077..16c79ef 100644 --- a/site/docs/install/dell3050.md +++ b/site/docs/install/dell3050.md @@ -81,15 +81,6 @@ is using this patchset from the author, Mate Kukri: Issues, as per Libreboot's testing, are as follows: -* Although USB ports seem to work, the Gerrit page linked above says that the - config is incorrect; need to investigate. -* HDA Verb: Libreboot patches the board to support this, which fixes the - headphone jack among other things. -* VBT: Libreboot patches the board to support this, though it's largely - optional on Linux/BSD. -* ACPI-based shutdown seems to falter a lot; sometimes the board will not turn - off after shut down, so you have hold the button down. Also, the button does - not seem to signal the OS that a shutdown must occur. * PWM fan controls broken, so the system always run in a low-rpm state, even under stress conditions, which could lead to overheating under stress. @@ -100,8 +91,12 @@ red wire powers it, so the resistor on the red wire will slow the fan down, but leave it running faster than on idle. You can also cap the CPU speed however you wish, via the `intel_pstate` driver. +An i7-6700k has been tested, delidded (thermal grizzly conductonaut under +the ihs) and arctic mx-6 paste on top (between ihs/cooler). On stress tests, +the CPU got just above 60c with the above 10ohm mod. + If you're using a 10ohm resistor on the fan power, make sure it's at least a 2W -one. +one, since this is a very low-resistance fan (higher wattage). Note that HDMI audio *does* work, but you have to select it in your audio server e.g. pipewire. The `pavucontrol` utility in Linux (with pipewire) lets