--- title: Flashing the Dell Latitude E6400 x-toc-enable: true ... Introduction ============ Initial flashing instructions for the E6400. **ROM images are available in the [Libreboot 20230423 release](../../news/libreboot20230423.md), and subsequent releases.** This guide is for those who want libreboot on their Latitude E6400 while they still have the original Dell BIOS present. This guide can also be followed (adapted) if you brick your E6400, to know how to recover. Blob-free initialisation! ========================= This board can boot entirely blob-free in the flash. The hardware is similar to that of ThinkPad X200, T400 etc where no-ME setup is possible. No-microcode setup feasible ---------------------------- The [microcode bugfixes/mitigations added for GM45](../../news/gm45microcode.md) are also applicable to this board, for users who are interested. Read that article for more information. Libreboot still recommends that boot with CPU microcode updates, by default, for all the reasons described by Libreboot's [Binary Blobs Reductions Policy](../../news/policy.md) but this board run reasonably well without them. A note about GPUs ----------------- We *believe* the dGPU models are PM45, and therefore will require a VGA blob for initialisation. This is currently unsupported in Libreboot. Models with iGPU (Intel graphics) are GM45, and fully supported in Libreboot with native initialisation. Flash chip size {#flashchips} =============== Use this to find out: flashrom -p internal We believe most/all are 4MB (32Mb) flash sizes, but larger ROM images are provided for people who wish to upgrade. MAC address {#macaddress} =========== Refer to [mac\_address.md](../hardware/mac_address.md). How to flash internally (no diassembly) ======================================= You can flash Libreboot directly from the vendor (Dell) BIOS, without taking the machine apart. It can be done entirely from Linux. It will probably also work on BSD systems, but it has only been testing on Linux thus far. Check `util/e6400-flash-unlock` in the `lbmk.git` repository, or in release archives for Libreboot releases from 20230423 onwards. Go in there: cd util/e6400-flash-unlock make With this program, you can unlock the flash in such a way where everything is writeable. Information about how to use it is in the `README.md` file which is included in that program's directory, or you can read it online here: Literally just run that program, and do what it says. You run it once, and shut down, and when you do, the system brings itself back up automatically. Then you run it and flash it unlocked. Then you run it again. The source code is intuitive enough that you can easily get the gist of it; it's writing some EC commands and changing some chipset config bits. The EC on this machine is hooked up to the `GPIO33` signal, sometimes called `HDA_DOCK_EN`, which sets the flash descriptor override thus disabling any flash protection by the IFD. It also bypasses the SMM BIOS lock protection by disabling SMIs, and Dell's BIOS doesn't set any other type of protection either such as writing to Protected Range registers. With this method, you can probably flash it within 5 minutes. Again, zero disassembly required! How to flash externally ========================= Refer to [spi.md](spi.md) as a guide for external re-flashing. The SPI flash chip shares a voltage rail with the ICH9 southbridge, which is not isolated using a diode. As a result, powering the flash chip externally causes the ICH9 to partially power up and attempt to drive the SPI clock pin low, which can interfere with programmers such as the Raspberry Pi. See [RPi Drive Strength](spi.md#rpi-drive-strength) for a workaround. Have a look online for videos showing how to disassemble, if you wish to externally re-flash.