update notes about dell 3050 micro
Signed-off-by: Leah Rowe <info@minifree.org>master
parent
163876482f
commit
d4203520d0
|
@ -81,15 +81,6 @@ is using this patchset from the author, Mate Kukri:
|
|||
|
||||
Issues, as per Libreboot's testing, are as follows:
|
||||
|
||||
* Although USB ports seem to work, the Gerrit page linked above says that the
|
||||
config is incorrect; need to investigate.
|
||||
* HDA Verb: Libreboot patches the board to support this, which fixes the
|
||||
headphone jack among other things.
|
||||
* VBT: Libreboot patches the board to support this, though it's largely
|
||||
optional on Linux/BSD.
|
||||
* ACPI-based shutdown seems to falter a lot; sometimes the board will not turn
|
||||
off after shut down, so you have hold the button down. Also, the button does
|
||||
not seem to signal the OS that a shutdown must occur.
|
||||
* PWM fan controls broken, so the system always run in a low-rpm state, even
|
||||
under stress conditions, which could lead to overheating under stress.
|
||||
|
||||
|
@ -100,8 +91,12 @@ red wire powers it, so the resistor on the red wire will slow the fan down, but
|
|||
leave it running faster than on idle. You can also cap the CPU speed however you
|
||||
wish, via the `intel_pstate` driver.
|
||||
|
||||
An i7-6700k has been tested, delidded (thermal grizzly conductonaut under
|
||||
the ihs) and arctic mx-6 paste on top (between ihs/cooler). On stress tests,
|
||||
the CPU got just above 60c with the above 10ohm mod.
|
||||
|
||||
If you're using a 10ohm resistor on the fan power, make sure it's at least a 2W
|
||||
one.
|
||||
one, since this is a very low-resistance fan (higher wattage).
|
||||
|
||||
Note that HDMI audio *does* work, but you have to select it in your audio
|
||||
server e.g. pipewire. The `pavucontrol` utility in Linux (with pipewire) lets
|
||||
|
|
Loading…
Reference in New Issue